在線客服

電話:0571-88029540

手機號碼:18072745805

     13336108719

QQ:2355823135 QQ:2355823134

当前位置 : 網站首頁 / 新聞資訊

新聞資訊

NEWS

  • 廚房油煙淨化器常見故障及維修你知道多少?
  • 本站編輯:体彩22选五走势图科技實業有限公司发布日期:2019-05-28 21:56 浏覽次數:

好多餐廳在長期使用廚房油煙淨化器后,发现净化效果就会降低,导致油烟不可以很好的被净化掉,并且在工作的时候会出各种罢工现象.这是为什么呢?今天与大家一起来学习一下厨房油煙淨化器常见故障及维修相关知识,分别如下:


After long-term use of kitchen lampblack purifier, many restaurants find that the purifying effect will be reduced, leading to lampblack can not be well purified, and there will be a variety of strikes at work. Why? Today, with you to learn about kitchen lampblack purifier common failures and maintenance-related knowledge, respectively, as follows:

2-160QQ60P0.png


第一,電機發熱嚴峻:定子繞組部分短路;含油軸承嚴峻缺油,應該及時進行清洗和維修,即可恢複淨化效果.


Firstly, the heat of the motor is severe: the stator winding is partly short-circuited; the oil bearing is severely short of oil, so it should be cleaned and repaired in time to restore the purification effect.


第二,按鍵開關不靈敏:電機轉矩下降,轉速變慢,應換上同規格電容;應修複或更換短路的繞組.


Second, the key switch is insensitive: motor torque decreases, speed slows, should be replaced with the same specifications of capacitors; should repair or replace short-circuit windings.


第三,潤滑不良發熱及處理辦法:要適量加油,若軸承毀壞,應更換軸承:各檔琴鍵開關能鎖住,機械功能良好,但不可以啓動電機,應檢查各檔開關的公共連線是不是斷路,若斷路應修複;若其中某檔按下電機不可以運轉,別的檔正常,應檢查失控的那一檔是不是觸點毀壞或連線脫落;按下開關電機能運轉,松開後鎖不住,檢查鎖不住的那一檔開關導電彈簧與導電片是不是接觸不上,或開關彈簧片脫落,位移.應調整彈簧片或更換開關;兩檔同時被鎖住.應檢查互鎖彈簧是不是位移、變形,若是應調整、修理互鎖彈簧.


Third, bad lubrication, heating and treatment methods: to properly refuel, if the bearings are damaged, the bearings should be replaced: each key switch can be locked, the mechanical function is good, but can not start the motor, should check whether the public connection of each switch is broken, if the break should be repaired; if one of the gears is not able to operate, the other gears are normal, should check whether the out-of-control gear is damaged or not. Or the connection will fall off; if the switch motor can run, it will not lock after loosening, check whether the conductive spring of the switch that cannot be locked can not contact with the conductive sheet, or the spring sheet of the switch will fall off and displace. The spring sheet should be adjusted or the switch should be replaced; the two gears should be locked at the same time. The displacement and deformation of the interlocking spring should be checked, and if the interlocking spring should be adjusted and repaired.


第四,油煙淨化器漏油:安装不当,仰角不足.要重新安装,使吸出的油能顺利流入集油盒;排油管脱落或破损,集油盒密封条破损.排油管脱落的应重新插牢,油管、密封条破损的应更换.


Fourth, oil leakage of fume purifier: improper installation and insufficient elevation angle. It is necessary to re-install the suction oil so that it can flow smoothly into the oil collecting tank; the oil draining pipe falls off or breaks down, and the sealing strip of the oil collecting box is damaged. The oil draining pipe should be re-inserted when it falls off, and the damaged oil pipeline and sealing strip should be replaced.


第五,油煙淨化器漏电:电源线、电机绕组绝缘破损而碰壳,应包扎好破损处或换新线、新绕组;元器件进水受潮,应查明进水原因,如果是排烟管安装不当,应重新安装,出口处稍弯下一些,以免雨水进入机内;元器件积污过多,绝缘降低.应清洗污垢,干燥处理后运用.


Fifth, fume purifier leakage: power cord, motor winding insulation damage and encrustation, should be wrapped up or new wires, new windings; components moisture intake, should find out the cause of water intake, if the flue gas pipe is not properly installed, should be re-installed, the outlet slightly bent down to avoid rainwater into the machine; components accumulated too much dirt, insulation reduced. Dirt should be cleaned and used after drying treatment.